![]() The flux cleans and prepares the area for maximum adhering capabilities. * Flux pieces before clamping and before soldering. * When clamping, make sure you use the clamps with flat ends which pivot this way you won’t be left with marks on your moonshine still. Make sure when installing the coil, the flow of the spiral goes downwards to ensure the correct flow needed.Ĭlamping * Clamping the copper is important when building a copper moonshine still the tighter you clamp the copper, the less solder you will have to use and a much stronger bond will be created. The coil cannot be spiraling from low to high or down too flat. Worm Calibration The coil for the worm needs to be installed in a manner where the coil spirals downwards. If this happens, use sand paper or wire brush to clean up and reflux, let it cool down before you try to solder again. Do not wait too long or the solder won’t take. Hold the flame on the fitting and heat it up until solder takes. Make sure you apply enough flux to all joints before soldering. Making sure everything lines up before soldering the pipes is important to ensure that your unit looks proper. ![]() ![]() Plumbing the Unit Once all of your pieces are ready to get installed, you need to line everything up on the table and get it nice and straight before you solder everything up. The tubing that does not go down much at all goes on the right side. The long tubing goes almost all the way down on the left side. Once you de- termine which side is the front and back, you then need to make sure the correct tubing gets installed. Thumper Pipe Instructions The seam is on the back side, the drain plug is on the front. ![]()
0 Comments
Leave a Reply. |